Bulb Replacement; Models With Halogen Headlamps - If Equipped - Dodge Challenger 2015 Operating Information Manual

BULB REPLACEMENT

NOTE:
Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as
atmospheric conditions change to allow the
condensation to change back into a vapor.
Turning the lamps on will usually accelerate
the clearing process.
Low Beam Headlamp, High Beam
Headlamp, Park/Turn Lamp —
Models with Halogen Headlamps —
If Equipped
To replace the passenger side lamps:
1. Open the hood.
2. Remove the headlamp cover.
3. Reach behind the passenger headlamp as-
sembly.
NOTE:
The park/turn lamps can also be accessed at
this point.
304
4. Turn the headlamp access cap counter-
clockwise to remove.
5. Remove bulb by turning it counter clockwise
and disconnect.
6. Install new bulb by turning it clockwise and
reconnect.
7. Reinstall headlamp access cap by turning it
clockwise and then reinstall headlamp cover.
To replace the driver side lamps:
1. Open the hood.
2. Remove the air cleaner filter cover by remov-
ing three fasteners and loosening the clean
air inlet clamp and then rotate cover off to the
side.
NOTE:
The cover has an electrical connector that
does not need to be disconnected if the
cover is rotated off to the side.
3. Remove one fastener on the lower air box to
remove and access the rear of the headlamp
assembly.
4. Reach behind the passenger headlamp as-
sembly.
5. Remove the headlamp cover.
6. Turn the headlamp access cap counter-
clockwise to remove.
7. Remove bulb by turn it counter clockwise
and disconnect.
8. Install new bulb by turning it clockwise and
reconnect.
9. Reinstall headlamp access cap by turning it
clockwise and then reinstall headlamp cover.
10. Reinstall engine air cleaner assembly.