Dodge Challenger 2015 Operating Information Manual page 84

Hide thumbs Also See for Challenger 2015:
Table of Contents

Advertisement

• A "Turn Signal On" message will appear
in the Drivers Information Display (DID)
and a continuous chime will sound if the
vehicle is driven more than 1 mi (1.6 km)
with either turn signal on.
Lane Change Assist
Tap the lever up or down once, without moving
beyond the detent, and the turn signal (right or
left) will flash three times then automatically turn
off.
High/Low Beam Switch
Push the multifunction lever away from you to
switch the headlights to high beam. Pull the
multifunction lever toward you to switch the
headlights back to low beam.
Flash-To-Pass
You can signal another vehicle with your head-
lights by lightly pulling the multifunction lever
toward you. This will turn on the high beam
headlights until the lever is released.
NOTE:
If the multifunction lever is held in the
flash-to pass position for more than 20 sec-
onds, the high beams will shut off.
Map/Reading Lights
These lights are mounted between the sun
visors on the overhead console. Each light is
turned on by pressing the lens. Press the lens a
second time to turn off the light. These lights
also turn on when a door is opened, or when the
UNLOCK button on the Remote Keyless Entry
(RKE) transmitter is pressed, or when the dim-
mer control is turned fully upward, past the
second detent.
Overhead Console
Interior Lights
The interior lights come on when a door is
opened.
To protect the battery, the interior lights will turn
off automatically 10 minutes after the ignition is
moved to the LOCK position. This will occur if
the interior lights were switched on manually or
are on because a door is open. This includes
the glove box light, but not the trunk light. To
restore interior light operation, either place the
ignition in the ON/RUN position or cycle the light
switch.
81

Advertisement

Table of Contents
loading

Table of Contents