Dodge Challenger 2015 Operating Information Manual page 173

seven blower speeds available. Adjusting the
blower will cause automatic mode to switch to
manual operation. The speeds can be selected
using either the blower control knob on the
faceplate or the buttons on the touchscreen as
follows:
Blower Control Knob On The Faceplate
The blower speed increases as you turn the
blower control knob clockwise from the lowest
blower setting. The blower speed decreases as
you turn the blower control knob counterclock-
wise.
Button On The Touchscreen
Use the small blower icon to reduce the blower
setting and the large blower icon to increase the
blower setting. Blower can also be selected by
pressing the blower bar area between the icons.
11. Modes
The airflow distribution mode can be adjusted
so air comes from the instrument panel outlets,
floor outlets and demist outlets. The Mode set-
tings are as follows:
170
• Panel Mode
Air comes from the outlets in the in-
strument panel. Each of these outlets
can be individually adjusted to direct
the flow of air. The air vanes of the
center outlets and outboard outlets can be
moved up and down or side to side to regulate
airflow direction. There is a shut off wheel
located below the air vanes to shut off or adjust
the amount of airflow from these outlets.
• Bi-Level Mode
Air comes from the instrument panel
outlets and floor outlets. A slight
amount of air is directed through the
defrost and side window demister
outlets.
NOTE:
BI-LEVEL mode is designed under comfort
conditions to provide cooler air out of the
panel outlets and warmer air from the floor
outlets.
• Floor Mode
Air comes from the floor outlets. A
slight amount of air is directed through
the defrost and side window demister
outlets.
• Mix Mode
Air comes from the floor, defrost and
side window demist outlets. This mode
works best in cold or snowy conditions.
12. Climate Control OFF Button
Press and release this button to turn the Cli-
mate Control ON/OFF.
13. Driver Temperature Control Down But-
ton (Uconnect® 8.4 Only)
Provides the driver with independent tempera-
ture control. Push the button on the faceplate
for cooler temperature settings or on the touch-
screen, press and slide the temperature bar
button towards the blue arrow for cooler tem-
perature settings.