Table of Contents
Advertisement
upon subsequent vehicle start-ups as long as
the malfunction exists. When the malfunction
indicator is illuminated, the system may not be
able to detect or signal low tire pressure as
intended. TPMS malfunctions may occur for a
variety of reasons, including the installation of
replacement or alternate tires or wheels on the
vehicle that prevent the TPMS from functioning
properly. Always check the TPMS malfunction
telltale after replacing one or more tires or
wheels on your vehicle, to ensure that the
replacement or alternate tires and wheels allow
the TPMS to continue to function properly.
CAUTION!
The TPMS has been optimized for the origi-
nal equipment tires and wheels. TPMS pres-
sures and warning have been established for
the tire size equipped on your vehicle. Un-
desirable system operation or sensor dam-
age may result when using replacement
equipment that is not of the same size, type,
and/or style. Aftermarket wheels can cause
126
CAUTION! (Continued)
sensor damage. Do not use tire sealant from
a can or balance beads if your vehicle is
equipped with a TPMS, as damage to the
sensors may result.
18. Electronic Stability Control (ESC) OFF
Indicator Light — If Equipped
Track or Full OFF.
19. Electronic
Activation/Malfunction Indicator Light — If
Equipped
(Continued)
the engine running. If the "ESC Activation/
This light indicates the Electronic
Stability Control (ESC) is off.
With Drive Modes the ESC OFF
indicator will be lit any time the
Traction modes is set to Sport,
Stability
Control
(ESC)
The "ESC Activation/Malfunction
Indicator Light" in the instrument
cluster will come on when the igni-
tion switch is turned to the ON/
RUN position. It should go out with
Malfunction Indicator Light" comes on continu-
ously with the engine running, a malfunction
has been detected in the ESC system. If this
light remains on after several ignition cycles,
and the vehicle has been driven several miles
(kilometers) at speeds greater than 30 mph
(48 km/h), see your authorized dealer as soon
as possible to have the problem diagnosed and
corrected.
NOTE:
• The "ESC Off Indicator Light" and the
"ESC Activation/Malfunction
Light" will come on momentarily each
time the ignition switch is turned to ON/
RUN.
• Each time the ignition is turned to ON/
RUN, the ESC system will be ON, even if it
was turned off previously.
• The ESC system will make buzzing or
clicking sounds when it is active. This is
normal; the sounds will stop when ESC
becomes inactive following the maneuver
that caused the ESC activation.
Indicator
Advertisement
Chapters
Table of Contents
