Dodge Challenger 2015 Operating Information Manual page 142

ParkSense® Volume" button on the touch-
screen, then select from "Low," "Med," or "High."
Press the back arrow/Done button on the touch-
screen to return to the previous menu.
ParkSense® will retain its last known configu-
ration state through ignition cycles.
• Blind Spot Alert
When this feature is selected, the Blind Spot
Alert feature Provides alerts, visual and/or au-
dible, to indicate objects in your blind spot. The
Blind Spot Alert feature can be activated in
Lights mode. When this mode is selected, the
Blind Spot Monitor (BSM) system is activated
and will only show a visual alert in the exterior
mirrors. When Lights & Chime mode is acti-
vated, the Blind Spot Monitor (BSM) will show a
visual alert in the exterior mirrors as well as an
audible alert when the turn signal is on. When
Off is selected, the Blind Spot Monitor (BSM)
system is deactivated. To change the Blind Spot
Alert status, press the "Off," "Lights," or "Lights
& Chime" button on the touchscreen. Then
press the back arrow/Done button on the touch-
screen.
NOTE:
If your vehicle has experienced any damage
in the area where the sensor is located, even
if the fascia is not damaged, the sensor may
have become misaligned. Take your vehicle
to an authorized dealer to verify sensor
alignment. Having a sensor that is mis-
aligned will result in the BSM not operating
to specification.
• ParkView® Backup Camera Active
Guidelines
Your vehicle may be equipped with the
ParkView® Rear Back Up Camera Active
Guidelines that allows you to see active guide-
lines over the ParkView Back up camera display
whenever the shift lever/gear selector is put into
REVERSE. The image will be displayed on the
radio touchscreen display along with a caution
note to "check entire surroundings" across the
top of the screen. After five seconds, this note
will disappear. To enable or disable, press the
"ParkView® Backup Camera Active Guidelines"
button on the touchscreen, and select "On" or
"Off." Press the back arrow/Done button on the
touchscreen to return to the previous menu.
• ParkView® Backup Camera Delay
When the vehicle is shifted out of REVERSE
(with camera delay turned OFF), the rear cam-
era mode is exited and the navigation or audio
screen appears again. When the vehicle is
shifted out of REVERSE (with camera delay
turned ON), the rear view image with dynamic
grid lines will be displayed for up to 10 seconds
after shifting out of "REVERSE" unless the
forward vehicle speed exceeds
(12 km/h), the transmission is shifted into PARK
or the ignition is switched to the OFF position.
To set the ParkView® Backup Camera Delay
press the "Controls" button on the touchscreen,
the "settings" button on the touchscreen, then
the "Safety & Assistance" button on the touch-
screen. Press the "Parkview Backup camera
Delay" button on the touchscreen and select
from "ON" or "OFF."
• Rain Sensing Auto Wipers
When this feature is selected, the system will
automatically activate the windshield wipers if it
8 mph
139