Dodge Challenger 2015 Operating Information Manual page 137

• Two sub menu pages one with Current value
displayed and one without the Current Value
displayed:
– Current MPG (or L/100 km)
– Range (miles or km)
– Average MPG (or L/100 km)
– The Max and Min values will correspond
to the particular engine requirements
• Lower end of gauge will be displayed in an
amber color and turn green as Fuel Economy
improves.
• MPG will have the gauge fill from the left
(clockwise).
• L/100 km will have the gauge fill from the
right (counter clockwise).
• Hold OK to reset average fuel economy
information.
134
Trip Info
Push and release the UP or DOWN arrow
button until the Trip Menu item is highlighted in
the DID (Toggle left or right to select Trip A or
Trip B). The Trip information will display the
following:
• Distance
• Average Fuel Economy
• Elapsed Time
Hold the OK button to reset feature information.
Audio
Push and release the UP or DOWN arrow
button until the Audio Menu displays in the DID.
Stored Messages
Push and release the UP or DOWN arrow
button until the Messages Menu item is high-
lighted in the DID. This feature shows the
number of stored warning messages. Pushing
the RIGHT arrow button will allow you to see
what the stored messages are.
Screen Setup
Push and release the UP or DOWN arrow
button until the Screen Setup Menu displays in
the DID. Push and release the OK button to
enter the sub-menus. The Screen Setup feature
allows you to change what information is dis-
played in the instrument cluster as well as the
location that information is displayed.
Diagnostics — If Equipped
Push and release the UP or DOWN arrow
button until the diagnostic Menu where the
Driver is able to view certain vehicle faults.
• Push OK to have the 1st code in the stack
sent
• There is a delay when the next diagnostic
code is requested during which the following
message is displayed:
• "Checking System for Diagnostic Codes"
• Driver must push the OK button again to see
the next Pcode otherwise current message
remains displayed.
• Driver exits when they cycle to another sub-
menu (up or down).
• Faults are displayed from oldest to the
newest.