IBM System x3750 M4 Type 8722 Installation And Service Manual page 98
Hide thumbs
Also See for System x3750 M4 Type 8722:
- Product manual (45 pages) ,
- Installation and service manual (882 pages)
Table of Contents
Advertisement
7. Use one of the following procedures:
8. Route the signal cables through the SAS cable guide and connect the signal
82
System x3750 M4 Types 8722 and 8733: Installation and Service Guide
a. To install the adapter on the system board, complete the following steps:
1) Open the PCIe retention latch.
2) Remove the PCIe filler bracket from the slot in which you want to
install the adapter.
3) Align the adapter so that the keys align correctly with the connector on
the system board.
4) Insert the adapter into the connector on the system board until it is
firmly seated.
Attention: Make sure that the adapter is seated correctly. Incomplete
insertion might cause damage to the system board or the adapter.
5) Close the PCIe retention latch.
6) Connect any cables to the adapter, if applicable.
7)
b. To install the adapter on the PCIe riser-card assembly, complete the
following steps:
1) Carefully grasp the riser card assembly by the blue touch points and
pull it up until the riser card assembly disengages from the connector
on the system board.
2) Open the PCIe retention latch.
3) Remove the PCIe filler bracket from the slot in which you want to
install the adapter.
4) Align the adapter so that the keys align correctly with the connector on
the riser card assembly.
5) Insert the adapter into the connector on the riser card until it is firmly
seated.
Attention: Make sure that the adapter is seated correctly. Incomplete
insertion might cause damage to the system board, the adapter, and the
PCIe riser card assembly.
6) Close the PCIe retention latch.
7) Connect any cables to the adapter, if applicable.
8) Reinstall the riser card assembly onto the system board.
cables to the drive backplane.
Note: Follow the general rule for connecting the SAS signal cables to the
adapter and drive backplane: port 0 on the adapter to port 0 on the drive
backplane and port 1 on the adapter to port 1 on the drive backplane
(depending on the type of drive backplanes you installed in the server).
Advertisement
Table of Contents
Troubleshooting
