Starting The Setup Utility; Setup Utility Menu Choices - IBM System x3750 M4 Type 8722 Installation And Service Manual

Starting the Setup utility

To start the Setup utility, complete the following steps:
1. Turn on the server.
2. When the prompt <F1> Setup is displayed, press F1. If you have set an
3. Select settings to view or change.

Setup utility menu choices

The following choices are on the UEFI Setup utility main menu. Depending on the
version of the UEFI firmware, some menu choices might differ slightly from these
descriptions. For more information on UEFI-compliant firmware, go to
http://www-947.ibm.com/systems/support/supportsite.wss/
docdisplay?lndocid=MIGR-5083207&brandind=5000008.
v System Information
v System Settings
128
System x3750 M4 Types 8722 and 8733: Installation and Service Guide
Note: Approximately 10 seconds after the server is connected to input power,
the power-on button becomes active.
administrator password, you must type the administrator password to access
the full Setup utility menu. If you do not type the administrator password, a
limited Setup utility menu is available.
Select this choice to view basic information about the server. When you make
changes through other choices in the Setup utility, some of those changes are
reflected in the system information; you cannot change settings directly in the
system information.
– System Summary
Select this choice to view configuration information, including the ID, speed,
and cache size of the microprocessors, machine type and model of the server,
the serial number, the system UUID, and the amount of installed memory.
When you make configuration changes through other choices in the Setup
utility, the changes are reflected in the system summary; you cannot change
settings directly in the system summary.
– Product Data
Select this choice to view, the revision level or issue date of the firmware, the
integrated management module and diagnostics code, and the version and
date.
Select this choice to view or change the server component settings. This choice is
on the full Setup utility menu only.
– Adapters and UEFI Drivers
Select this choice if you want to use the configuration capabilities of the
device drivers to configure the device.
– Processors
Select this choice to view or change the processor settings.
– Memory
Select this choice to view or change the memory settings. To configure
memory mirroring, select System Settings → Memory → Memory Mode →
Mirroring.
– Devices and I/O Ports
Select this choice to view or change settings for devices and input/output
(I/O) ports. You can configure the serial ports; configure remote console