IBM System x3750 M4 Type 8722 Installation And Service Manual page 146

130
System x3750 M4 Types 8722 and 8733: Installation and Service Guide
Select this choice to enable or disable UEFI to interact with PCI mass
storage devices that are non-UEFI compliant.
- Infinite Boot Retry
Select this choice to enable or disable the infinitely retry of the Legacy Boot.
– System Security
Select this choice to view or configure Trusted Platform Module (TPM)
support.
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module.
- Power Restore Policy
Select this choice to determine the mode of operation to which the server
will be restored after a power outage occurs. You can select Always Off,
Restore, or Always On to restore the server the state that it was set to at
the time of the power outage.
- Commands on USB Interface Preference
Select this choice to enable or disable the Ethernet over USB interface on
the IMM.
- Network Configuration
Select this choice to view the systems-management network interface port,
the IMM MAC address, the current IMM IP address, the system Ethernet
MAC addresses, and the host name; define the static IMM IP address,
subnet mask, and gateway address; specify whether to use the static IP
address or have DHCP assign the IMM IP address; save the network
changes; and reset the IMM.
- Reset IMM to Defaults
Select this choice to reset the IMM to the default settings.
- Reset IMM
Select this choice to reset the IMM settings.
– Recovery
Select this choice to view or set the number of POST attempts and configure
start recovery attempts.
- POST attempts
Select this choice to view or set the number of attempts to POST before the
recovery is started.
- System Recovery
Select this choice to view or set the time to start the system recovery
attempt.
v POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
v POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
v Reboot System on NMI
Select this choice to enable or disable restarting the server whenever a
nonmaskable interrupt (NMI) occurs. The default is Enabled.
v Halt On Server Error