IBM System x3750 M4 Type 8722 Installation And Service Manual page 255

4. Removing a 1400-watt hot-swap power supply.
a. Press and hold the orange release tab to the left. Grasp the handle and pull
the power supply out of the server.
Power supply
release tab
b. Set the power supply aside.
c. Go to step 6 on page 240.
5. Removing a 900-watt hot-swap power supply.
a. Press and hold the orange release tab to the left. Grasp the power supply
handle and pull the power supply out of the server.
Spacer
Spacer
release tab
Power supply
release tab
b. Facing the rear of the server, pull the spacer release tab on the power
supply spacer to the right, use your finger to grasp the hole on the side of
the spacer, and slide the power supply spacer out of the server.
Note: You only need to remove the spacer if you are removing all of the
900-watt power supplies and installing 1400-watt power supplies.
c. Set the power supply spacer aside.
1400-watt
power supply
900-watt
power supply
Chapter 6. Removing and replacing components
239