IBM System x3750 M4 Type 8722 Installation And Service Manual page 90

Attention: Some cluster solutions require specific code levels or coordinated code
updates. If the device is part of a cluster solution, verify that the latest level of
code is supported for the cluster solution before you update the code.
Note:
v For additional information and notes about installing adapters, see "Installing an
v Follow the general rule for connecting the SAS signal cables to the adapter and
To install the adapter if your server model did not come with this adapter,
complete the following steps.
10. Align the adapter so that the keys align correctly with the connector on the
11. Insert the adapter into the connector on the riser-card until it is firmly seated.
12. Close the PCIe retention latch.
13. Connect the SAS cables to the adapter.
14. Reinstall the riser-card assembly onto the system board.
15. Route the signal cables through the SAS cable guide and connect the signal
74
System x3750 M4 Types 8722 and 8733: Installation and Service Guide
adapter" on page 66.
drive backplane: port 0 on the adapter to port 0 on the drive backplane and port
1 on the adapter to port 1 on the drive backplane (depending on the type of
drive backplane you install in the server).
1. Read the safety information that begins on page "Safety" on page vii and
"Installation guidelines" on page 33.
2. Turn off the server (see "Turning off the server" on page 21) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables from the server.
3. Remove the top cover (see "Removing the server top cover" on page 36).
4. Remove the fan cage assembly (see "Removing the fan cage assembly" on
page 40).
5. Remove the microprocessor and memory expansion tray (see "Removing the
microprocessor and memory expansion tray assembly" on page 278) or DIMM
air baffle (see "Removing the DIMM air baffle" on page 210), whichever one is
installed.
6. Grasp the riser-card assembly by the blue touch points and pull it up until the
riser-card assembly disengages from the connector on the system board; then,
set it aside.
7. Touch the static-protective package that contains the adapter to any unpainted
surface on the outside of the server; then, grasp the adapter by the top edge
or upper corners of the adapter and remove it from the package.
8. Make sure that a full-height bracket is installed on the card.
9. Open the PCIe retention latch.
riser-card assembly.
Attention: Incomplete insertion might cause damage to the server or the
adapter.
cables to the drive backplane.
Note: Follow the general rule for connecting the SAS signal cables to the
adapter and drive backplane: port 0 on the adapter to port 0 on the drive
backplane and port 1 on the adapter to port 1 on the drive backplane
(depending on the type of drive backplanes you installed in the server).