IBM System x3750 M4 Type 8722 Installation And Service Manual page 267

c. Disconnect the battery cable or flash power module cable from the cache
card.
d. Press the black retention clip toward the front of the server and lift the
cache card out of the server and set it aside.
e. Go to step 6.
5. If the cache card is installed on a RAID adapter, complete the following steps:
a. Disconnect the cable from the battery or flash power module in the
battery/flash power module tray located on top of the USB/video assembly.
b. Grasp the riser-card assembly at the blue touch points and pull it up until
the riser-card assembly disengages from the connector on the system board.
c. Disconnect the cache card cable from the cache card on the RAID adapter.
d. Remove the adapter from the riser-card assembly (see "Removing an
adapter" on page 212).
e. Press the black retention clip away from the cache card and lift the cache
card off the adapter and set it aside.
RAID cache
card
6. If you are instructed to return the cache card, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
RAID cache card
Retention
tab
Retention
bracket
Chapter 6. Removing and replacing components
Release
tab
RAID cache
card connector
Adapter
251