Brother 891-Z02 Operation Manual page 86

Symptom
The mat or the material
catches on a feed roller
when the mat is being
inserted.
The mat or the material
catches on a feed roller
during cutting/drawing.
The mat is fed in at an
angle and is not fed
during cutting/drawing.
The material to be cut/
drawn or original to be
scanned peels off during
cutting/scanning.
Cutting
Symptom
The material being cut
catches on the tip of the
cutting blade.
The machine stopped
while an operation is
being performed.
Not all of the material to
be cut is cut. Some
areas remain uncut.
84
Possible Causes (or Results)
The mat's adhesive strength has
decreased, or the material is not
secured.
The material extends from the
adhesive area of the mat.
- The mat's adhesive strength has
decreased, or the material is not
secured.
- The material extends from the
adhesive area of the mat.
Possible Causes (or Results)
Dust or lint has accumulated in the
holder.
The blade is worn.
The material being cut is
incompatible with this machine.
For safety, the machine stops
operating if the panel is touched
while cutting or drawing.
A blade appropriate for the material
being cut is not used.
The blade extension from the blade
holder is too little.
If cutting is not possible even though
the blade extension or cutting
pressure is set higher than
necessary, the blade may be
chipped.
The mat's adhesive strength has
decreased, or the material is not
secured.
The blade is worn.
The material is incompatible with
this machine.
The cutting pressure ("Cut
Pressure") is incorrect.
Dust or lint has accumulated in the
holder.
The spacing between arranged
patterns is too small.
Solutions
Press the "Feed" button to feed out the
mat, and then replace the mat with a new
one.
Press the "Feed" button to feed out the
mat, and then attach the material while
keeping it within the adhesive area of the
mat.
Press the "Start/Stop" button to stop the
operation. Follow the instructions on the
screen, and press the "Feed" button to
feed out the mat.
If the mat does not feed out, turn off the
machine, remove the holder, and then
manually feed out the mat.
After feeding out the mat, replace it with a
new one or attach the material while
keeping it within the adhesive area of the
mat.
Solutions
Clean the holder.
Replace the blade with a new one.
Replace the material with one compatible
with this machine.
Follow the instructions in the message
that appears in the screen. Touch the
"OK" key to move the carriage to its initial
position. Load the mat and perform the
operation again.
Use a blade appropriate for the material
being cut.
Remove the holder from the carriage, and
then adjust the blade extension.
Replace the blade with a new one.
Replace the mat with a new one.
Replace the blade with a new one.
Replace the material with one compatible
with this machine.
Adjust the setting for "Cut Pressure" in the
settings screen.
Clean the holder.
Rearrange the patterns to slightly separate
them.
Set the number to "3" or higher in the
"Pattern Interval" setting, and then
rearrange the patterns or perform the auto
layout function.
Reference
page 28
page 76
page 18
page 28
page 18
page 28
page 76
Reference
page 78
page 76
page 16
—
page 24
page 24
page 76
page 76
page 76
page 16
page 24
page 30
page 78
page 31
page 46