Brother 891-Z02 Operation Manual page 61

■ Drawing
a
Touch the "Draw" key.
A preview of the line to be drawn appears.
The "Start/Stop" button in the operation panel
lights up.
b
Adjust the pen pressure.
For details on adjusting the drawing pressure, see step
e
(page 57) in "Drawing".
c
Press the "Start/Stop" button to start drawing.
When drawing is finished, the message appears
in the screen. After you touch the "OK" key, the
draw/cut selection screen appears.
• To perform trial drawing operations to adjust
the drawing pressure, repeat steps
c
in this section.
• To cut around the drawn patterns, keep the mat
inserted into the slot without pressing
and continue with the following cutting
procedure.
■ Cutting
a
Touch the "Cut" key.
b
Remove the pen holder, and then install the
blade holder.
a
through
• After use, remove the pen from the pen holder,
,
• Please remove protective cap from blade
• Do not allow infants/children to put the
A preview of the line to be cut appears.
The "Start/Stop" button in the operation panel
lights up.
Note
and then attach the cap to the pen before
storing it.
CAUTION
holder before placing it into the machine
carriage.
protective caps in their mouths.
3
59