Download  Print this page

Advertisement

■ Saving Data
a
Select the destination where the data will be
saved.
Select the desired location. For this example, select the
machine.
a
b
a Machine
b USB flash drive
c Computer
d ScanNCutCanvas (Wireless network models
only. This is available only after a connection
has been established with ScanNCutCanvas.
For details, refer to "Wireless Network Setup
Guide".)
Touching a key starts saving the data. When the
data has been saved, the following message
appears.
b
Touch the "OK" key to finish saving the data.
The destination memory selection screen appears
again.
c
Press
in the operation panel to feed out
the mat, and then peel off the original from the
mat.
70
■ Recalling Cutting Data
Saved cutting data can be recalled for cutting.
a
Attach the material for cutting to the mat, and
then load the mat.
• For details on attaching the material, see "Mat and
Material Combinations" on page 16.
• For details on loading the mat, see "Loading the
Mat" on page 27.
d
b
Recall the saved cutting data.
• For details on recalling data, follow the procedure
c
under "Recalling" on page 52.
A preview of the pattern layout appears.
c
Edit the cutting data as necessary, and then cut
or draw.
For details on finishing cutting, follow the procedures
under "Loading the Mat" (page 27) and "Cutting"
(page 28).

Advertisement

Table of Contents

   Also See for Brother 891-Z02

This manual is also suitable for:

891-z03891-z04

Comments to this Manuals

Symbols: 0
Latest comments: