Step 2: Remove Loudspeaker - Cisco TelePresence MX800 Single Replacement Manual

Cisco TelePresence MX800 Single
Contents
Replace the dual camera module
Step 2: Remove loudspeakers from positions 2, 3, 5 and 6
The illustrations below show the loudspeaker in position 3
for the single camera version. Perform these steps for the
loudspeakers in positions 2, 3, 5 and 6 for the dual camera
version.
When reconnecting the loudspeakers, make sure to
connect the correct cable. The cables are marked with the
loudspeaker's position (see illustration). Note that position 4
is not in use.
Remove screw.
2a
PT4x10, Torx T20
D15298.01 MX800 Single Replacement Guide, MARCH 2015.
Introduction Grilles and covers
(page 2 of 7)
Pull loudspeaker 10-15 cm (4-6 inch) out.
2b
Speakers and cameras Speakers and cameras
Loudspeaker
positions
2
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
20
Replacement Guide
Codec and monitor Appendix
3
5
6
Unplug the cable from the connector
2c
on the back of the loudspeaker.