Step 2: Remove Loudspeaker - Cisco TelePresence MX800 Single Replacement Manual

Cisco TelePresence MX800 Single
Contents
Replace the single camera module
Step 2: Remove loudspeakers from positions 3, 4 and 5
The illustrations show the loudspeaker in position 3.
Repeat the steps for the loudspeakers in positions 4 and 5.
When reconnecting the loudspeakers, make sure to
connect the correct cable. The cables are marked with the
loudspeaker's position (see illustration).
Remove screw.
2a
PT4x10, Torx T20
D15298.01 MX800 Single Replacement Guide, MARCH 2015.
Introduction Grilles and covers
(page 2 of 6)
Pull loudspeaker 10-15 cm (4-6 inch) out.
2b
Speakers and cameras Speakers and cameras
Loudspeaker
positions
3
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
14
Replacement Guide
Codec and monitor Appendix
4
5
Unplug the cable from the connector
2c
on the back of the loudspeaker.