Configuring Ivr Permission; Figure 4: Create An Ivr On Ucm6100 - Default Setting; Figure 5: Create An Ivr On Ucm6100 - Dial Trunk Enabled - Grandstream Networks UCM6100 Configuring Permission

CONFIGURING IVR PERMISSION

When creating an IVR under PBX->Call Features->IVR, users shall see "Dial Trunk" and "Permission"
options. By default, the "Dial Trunk" option is disabled. Also, the "Permission" level is set to "Internal"
(lowest level) and not configurable.

Figure 4: Create an IVR on UCM6100 - Default Setting

If "Dial Trunk" is enabled, users could specify the IVR permission level. Therefore, the calls coming into
IVR can dial outbound via trunk. In this case, the UCM6100 will compare the IVR's permission level with
the outbound route's privilege level. If the IVR's permission level is higher than (or equal to) the outbound
route's privilege level, the call will be allowed to go through.

Figure 5: Create an IVR on UCM6100 - Dial Trunk Enabled

* Asterisk is a Registered Trademark of Digium, Inc.
Firmware Version 1.0.1.25 Configuring Permission/Privilege Level Settings on UCM6100 Page 7 of 7