Sinclair ASGE-09A Service Manual page 117

U-MATCH AIR CONDITIONERS
10. Assembly of new
coping
Disassembly and Assembly of Compressor
Remark : Make sure there isn't any refrigerant in pipe system and the power supply is cut off before removal of the
compressor..
Step
1. Disassembly
compressor wires
2. Disassembly of fixing nuts
on compressor
3. Disassembly of suction
and discharge pipe
Illustration
of
●Put the new coping into the
right position on the unit.
●Screw
surrounding fixing screw
with screwdriver.
Handling Instruction
● Loose the fixing screw for
the power supply wire with
Disassemble
screwdriver.
compressor wire
●Pull down the power supply
wire.
●Attention: During removal
of the power supply wire,
mark wire color with the
corresponding joint number
in case of wrong connection.
● Disassemble the fixing nut
Disassemble fixing
on the
nut of compressor
wrench.
●Heat
Disassemble discharge pipe with gas
suction and welding
discharge pipe compressor.
●Provide nitrogen protection
during gas welding and the
nitrogen pressure should be
0.5±0.1kgf/cm
pressure ） .
●Please
heating
surrounding
should be burnt by high
temperature.
MAINTENANCE
down the
compressor with
the suction and
before removing
2
（ relative
pay attention to
in case that
materials
116