Assembly Of Cylinder Block - Volkswagen Taro 1989 Workshop Manual

ASSEMBLY OF CYLINDER BLOCK
(See page 52)
NOTE
Thoroughly clean all parts to be assembled
Before Installing the parts, apply new engine oil to all sitdlng
and rotatlng
sulfaces
Replace all gaskets, and oil seals with
new
pans.
1.
Fl main bearings In cylinder block and bearing caps
(a) Place the upper bearings in the cylmder block
(b) Place the lower bearings in the main bearing caps
CAUTION Ft the bearing with the oil hole In the block
2.
Fit upper thrust washers
Insert the thrust washers of the crankshafi bearing
3
into the
cfllnder block, the oil grooves (1) must face outwards.
3.
Place cmnkshafl on cylinder block
4.
Fl main bearing caps and lower thrust washers
NOTE Each bearing cap
IS
numbered
(a) Flt the thrust washers on the No 3 bearing cap wlth the
grooves facing outward
( l )
=
Oil Groove
(b) Flt the bearing caps
In
their proper locat~on
12)
=
Bearina Cao No
3
(3)
=
0ear1nG cab
NO
I, 2 . 4 and S
(4) =
Front