After Installation; Fit Push Rods And Rocker Shaft Assembly - Volkswagen Taro 1989 Workshop Manual

(b) Hold the push rod wiih SST until the rocker shaft assembly
is completely installed
SST 09270-71010
SST
, + , I
/
- 1
(C)
Fit the rocker shaft assembly on the cylinder head
2.
F l push rods and rocker shan assembly
(a) Make sure the push rod (1) arefmed in the correct order.
3.
Fi cylinder head cover
4. Fi tubes and spark plugs
Toraue 18 Nm
1
I
5 3 1
2
4
AFTER INSTALLATION
NOTE
Do
not keep the push rods apalftrom the rocker arms
while tightening the bolts and nuts.
(d) Fi
and
unlormly tighten the two bolts and three nuts in
the several stages, in the sequence shown.
Torque- 24 Nm
(e)
Remove the SST from the push rods and rocker shaft
assembiv.
1.
Fi Vacuum pipe w l h vacuum hoses to cylindl
carburetor
2.
Fit heater pipe bracket to exhaust manifold
3.
Connect fuel hoses t o fuel pump and carbure
4.
FI air suction (AS) reed valve with air injectio~
to cylinder head
5. Fill w l h englne coolant (See page 114)
6. Stalt engine and check for leaks
7.
Check engine oil level (See page 11)