Inspection Of Valve Lifter Bores; Install New Camshaft Bearing; Install Expansion Plug - Volkswagen Taro 1989 Workshop Manual

C. Install new camshan bearing
(a) Align the oil holes of the bearing and cyl~nder block.
(I)
=
Upward
(b) Using SST, ~nstall the bearlngs
0921540250)
(2)
=
Front
D. Check camshaft
od
clearance (See page 66)
E.
Install expansion plug
(a) Apply seal packing (3) to the expanslon plug sutface of the
cyl~nder block
Seal packing
Part No AMV 188 200 03 or equivalent
(b) Using a hammer, tap in a new expanslon plug until 11s
surface is flush with the cglnder black edge
INSPECTION OF VALVE LIFTER BORES
Inspect valve liner
011
clearance
(a) Usmg cailpers, measure the valve
liner bore dlameter
Bore dlameter 21 417
-
21 443 mm
(b) Subtract the valve liner diameter measurement (See
page 46) from the valve llner bare d~ameter measurement
Standard oil clearance
0 013
-
0 056 mm
Maxtmum
011
clearance 0 10 mm
If the clearance is greater than maximum, replace the valve
I'mers