Remove And Fit Engine - Volkswagen Taro 1989 Workshop Manual

(b) When separating electrical connectors, pull on the con-
nector Rsdf (2). not the wires (1)
(c) When disconnecting vacuum hoses, pull on the endof t h ~
hose
(4).
not the middle (3).
(d) When steam cleaning an engine. protect the distributor.
coil, air filter, and carburetor from water
(e) Never use an impact wrench to remove or install tempera-
ture sw~tches or temperature sensors
(fl
When checklng continuity at the wire connector, insen the
tester probe carefully to prevent terminals from bending.
(g) When using a vacuum gauge, nwer force the hose onto a
connector that is too large Use a stepdown adaptor m-
stead Once the hose has been stretched, R may leak
13 Tag hoses before disconnecting them:
(a) When disconnecting vacuum hoses, use tags to identity
how they should be reconnected
(1)
VTV for TP. whiie side
(2)
VN
for TP, black slde
(b) Aner completing a job, double check that the vacuum hoses
are properly connected A label under the hood shows the
proper layout.
R E M O V E A N D F I T E N G I N E
in the workshop the engine can be removed with an overhead crane. When replacing the engine tighten the bolts se
curing the englne mountings. observing the torque values listed in the table on page VII. The tordue valuesfor the
bolts between engine and drive line are listed in the sector on ''Clutch and Gear Bof' No other special proceedures
need to be obsewed For that reason, no special
instructions
for removing and fming the englne are included.