Installation Of Distributor - Volkswagen Taro 1989 Workshop Manual

INSTALLATION OF DISTRIBUTOR
Set No.
1
cylinder to TDC/compression
Set to TDCIcompression in the following manner
(a) Remove the No 1 spark plug
(b)
P
ace your l nger over me hole uf the No 1 smrr p i ~ g
dno rotate the cmnksnan clocrwlse 10 TOC f prebsurc
s
tell
on your
ffnqer lnls
S
TDC compress on of Ine No 1 cyl
tnder If not, repeat the process
(C) Install the No 1 spark plug.
Set oil pump drive rotor slot
Posltion the slot on the top end of the d i i e rotor in the direction,
as show in the diagram.
F t distributor
(a) Align the groove (2) of the housing with the drill mark (3) of
the driven gear (not driven gear straight pm)
(b) Insert the dlstribufor, allgnlng the center of the Range with
that of the bolt hole on the cylinder block.
(C) L~ghtly tighten the holddown bolt
Connect high-tension cords
Flnng order 1-3-4-2
Connect distrlbmor connector
Connect vacuum hose
Adjust ignnion timing (See page 13,
14)