Assembly Of Oil Pump; Installation Of Oil Pump - Volkswagen Taro 1989 Workshop Manual

ASSEMBLY OF OIL PUMP
(See page 123)
1 .
Install drive and driven rotors
Install the rotors so the punch marks (1) are facing upward
toward the pump body.
2.
Install oil pump cover
Install the oil pump cover with the three bolts Torque the bolts
Torque 7 8 N m
3. lnstall relief valve, spring and relief valve plug
lnsen the relief valve
(2)
and sprlng (3), and install the rellef
valve plug
(4)
Torque 37 Nm
4. Check
oil
pump
operation
(See page 124)
INSTALLATION OF OIL PUMP
1.
Fit oil pump
Frt the oil pump with the bolt
Torque the bolt
Torque 18 Nm
2. Fit oil Strainer
(a) Place a new O-nng an the oil stralner !n positlan
(b) Fi n
and torque the WO bolts mounting the all pump
cover to the ail strainer
Torque 17 Nm
(C)
Fit and torque the two bolts mounting the oil stralner on
the cyllnder block
Torque 12 Nm
3.
Ffi oil pan
(a) Remove any ail packing material and be careful not
to drop any oil on the contacting surfaces of the 011
pan and cylinder block
Usmg a razor blade and gasket scraper, remove all the
old packing material from the gasket surfaces and seallng
groove
.
Thoroughly clean all components to remove all the loose
materlal
.
Clean bath sealing surfaces wllh a non resldue solvent
CAUTION Do not use
a
solvent whlch will aflect the palnted
surlaces