(b) install the screw.
(C) Pack hlgh-temperature grease lnto the cam
(d) Press on the grease stopper with your flnger
4.
Install governor springs
5.
Fit breaker plate
(a) Fa the four clips
on
the breaker plate lnto the housing slots
(b) Fit one end of the lead wire and two plate washers wlth
the two screws
6.
Fit vacuum advancer
(a) insert the advancer into the distributor and posnion the
lever hole over the plate pin
(b) Fa the E-ring on the pin
(C)
Fit the Screw to the distributor body
7. Fit and adjust breaker point
(a) Clean the contact surfaces of the polnts wlth a plece of
cloth saturated in solvent
(b) Apply high-temperature grease to the heel of the rubbtng
block
(C)
Loosenly 111 the breaker point and one end of lead
wlre
( l )
with the two screws
(d) Usmg a feeler gauge, adjust the gap between the Governor
shaft and rubblng block.
Rubblng blocklGovernor shaft gap
0
45 mm