Canon EOS C300 Mark II Instruction Manual page 57

Icon/Display
Recording operation:
STBY, ÜREC
Clip recording: record standby, recording.
INT STBY, ÜINT,
Interval recording (A 117): record standby (before the sequence has started), record
ÜINT REC
standby (once the sequence has started), recording.
• In record standby mode before the interval recording sequence has started, [INT]
flashes.
FRM STBY, ÜFRM STBY,
Frame recording (A 116): record standby (before the sequence has started), record
ÜFRM REC
standby (once the sequence has started), recording.
• In record standby mode before the frame recording sequence has started, [FRM]
flashes.
S&F STBY, ÜS&F REC
Slow & fast motion recording (A 113): record standby, recording.
PRE REC STBY, Pre-recording (A 115): record standby, recording.
ÜPRE REC
1s - 10m00s Interval recording counter (A 117)
00.00P, 00.00i Frame rate (A 62)
• During slow & fast motion recording, the shooting frame rate is also displayed
(000/00.00P).
REC`, STBY` Output recording command (A 185)
U
Genlock (A 93)
00:00:00.00, 00:00:00:00 Time code (A 88)
Right side of the screen
Icon/Display
8 0000
Approximate number of photos that can be recorded on the SD card (A 175)
YCC422 10 bit, Color sampling (A 62)
RGB444 10 bit,
RGB444 12 bit
0000x0000 Resolution (A 62)
, , Output terminals not active (A 163)
T (in red)
Output onscreen displays (A 168)
GPS signal (A 108): continuously on - satellite signal acquired; flashing - satellite
signal not acquired.
• Displayed only when an optional GP-E1 GPS Receiver is connected to the camera.
Q
User memo (A 106)
00 00 00 00 User bit (A 91)
CH0/CH0 Audio output channels (A 169)
Date/time
Description
Description
Recording Video
Custom Display
2: [Recording Mode]
57
2: [Interval Counter]
2: [Frame Rate]
2: [Rec Command]
2: [Genlock]
2: [Time Code]
Custom Display
2: [Remaining Photos]
2: [Resolution/
Color Sampling]
2: [Resolution/
Color Sampling]
2: [Output Terminals
Status]
2: [OSD Output]
2: [GPS]
2: [User Memo]
2: [User Bit]
2: [Monitor Channels]
2: [Date/Time]