Adjusting the Black Balance
Adjusting the Black Balance
You can have the camera adjust the black balance automatically when ambient temperature changes
considerably or if there is a noticeable change in a true black video signal.
52
Operating modes:
1 Attach the body cap to the lens mount.
• If a lens was attached, remove the lens and replace the body cap.
2 Open the [ABB] screen.
[v Camera Setup] > [ABB]
3 Select [OK] and then press SET.
• The automatic black balance procedure will start. It will take approximately 40 seconds when the frame rate
is set to 23.98P or 24.00P.
4 When the confirmation message appears, press SET.
• If the sensor is not completely shielded from light, [Error] will appear on the screen. Press SET and repeat
the procedure from the beginning.
NOTES
• Adjusting the black balance is necessary in the following cases:
- When using the camera for the very first time or after a long period of not using it.
- After sudden or extreme changes in ambient temperature.
- After changing the ISO speed/gain settings.
- After resetting all the camera's settings.
• During the adjustment of the black balance, you may notice some irregular displays appear on the screen. This
is not a malfunction.
[v Camera Setup]
[ABB]