Pre-Recording Mode - Canon EOS C300 Mark II Instruction Manual

Pre-recording Mode

When pre-recording mode is activated, the camera starts recording
continuously into a temporary memory (approx. 3 seconds) so when you
press the START/STOP button, the clip will contain also a few seconds of
video and audio recorded before you pressed the button.
1 Open the [Recording Mode] submenu.
[3 Recording/Media Setup] > [Recording Mode]
2 Select [Pre-Recording] and then press SET.
• [PRE REC STBY] appears at the top of the screen.
3 Press the START/STOP button to begin recording.
• The tally lamp illuminates.
• [PRE REC STBY] changes to [Ü PRE REC] while recording.
4 Press the START/STOP button again to stop recording.
• The camera records the clip, including a few seconds of video and audio recorded before the START/STOP
button was pressed.
• The tally lamp goes out and [PRE REC STBY] appears at the top of the screen.
5 When you have finished recording, turn off the special recording mode.
• Repeat steps 1 and 2 selecting [Normal Recording] instead.
NOTES NOTES
• About the time code during pre-recording mode:
- The time code of the clip will start a few seconds before the START/STOP button was pressed.
- The time code will be recorded with the running mode set to [Free Run].
- If the time code mode was set to [Regen.], or to [Preset] with [Rec Run] running mode, the time code
running mode will be changed automatically to [Free Run] when pre-recording is activated.
- When the special recording mode is deactivated, the time code running mode will return to its previous
setting.
• You can use only one special recording mode at a time.
• If the system frequency is changed, pre-recording mode will be canceled.
Special Recording Modes
[3 Recording/Media Setup]
[Recording Mode]
[Normal Recording]
115