Setting The User Bit - Canon EOS C300 Mark II Instruction Manual

Setting the User Bit

The user bit display can be selected from the date or the time of
recording, or an identification code consisting of 8 characters in the
hexadecimal system. There are sixteen possible characters: the numbers
0 to 9 and the letters A to F.
If user bit information is being received along with an external time code,
you can also record the external user bit with the clip (A 94).
Operating modes:
1 Open the user bit [Type] submenu.
[¢ Picture/Terminals Setup] > [User Bit] > [Type]
2 Select the desired user bit type and press SET.
• Select [Setting] to set your own identification code, [Time] to use the time as the user bit, or [Date] to use the
date as the user bit.
• If you selected [Time] or [Date], the rest of the procedure is not necessary. If you selected [Setting], continue
the procedure to set the identification code.
3 Select [Set] and then press SET.
• The user bit setting screen appears with an orange selection frame on the leftmost digit.
• To reset the user bit to [00 00 00 00], select [Reset] instead.
4 Push the joystick up/down or turn the SELECT dial to select the first character and press SET to
move to the next.
• Change the rest of the characters in the same way.
• Press the CANCEL button to close the screen without setting the user bit.
5 Select [Set] and press SET to close the screen.
Setting the User Bit
[¢ Picture/Terminals Setup]
[User Bit]
[Type]
[Setting]
91