Table of Contents
Advertisement
11-1. AWA
The AWA (Audible Weighing Assist) function will assist you to count a certain amount
of pieces by listening to the buzzer sound. The buzzer sound changes its interval as
the pieces getting close to, and stops at, the target count.
There are three modes of operation. These can be selected by the
♫ Off mode: AWA function disabled.
♫ Target mode: To set the number of pieces that you will count.
♫ Interval mode: To set the number of pieces as an interval count. For example,
when 20 pieces is set as an interval count, the target count will be 20, 40, 60,
... pieces.
The buzzer starts to beep at the "target count – 9" pieces. As you add pieces and
the count is getting close to the target, the buzzer changes its interval of beeps,
shorter and shorter. Finally it stops at the target count.
The buzzer will beep again for "target count + 1, 2, 3 or 4" pieces.
The minimum number of pieces to set is 10.
The number of pieces is set to less than 50 in the interval mode, the buzzer will start
to beep at the "target count – 5" pieces.
You cannot set a minus target or interval count. But the AWA function works for
negative pieces, too.
The AWA function should be disabled when the comparator buzzer is used.
11-2. To Enable/Disable the AWA Function
Press the
set. The display moves among these setting modes cyclically by pressing the
to select one of them.
Press the RESET key in the setting modes, the scale returns to normal without
changing the AWA function setting and the unit weight you are using.
Off Mode Setting
1. The count display shows "off" blinking.
2. When you do not use the AWA function, press
the
ENTER
normal with the AWA function deactivated.
Or, move to the other mode setting by pressing
the
key.
11. AWA FUNCTION
Audible Weighing Assist
key, then the display will show one of the three modes of operation to
key. The display returns to
888.
WEIGHT
88-0. 0
39
key.
key
COUNT
o
ff02
UNIT WEIGHT
008
11Hi00
8
Hide quick links:
Advertisement
Table of Contents
