Basic Operations - A&D HC-30Ki Instruction Manual

3-1. Basic Operations

Turn The Power ON and OFF
1. Press the ON/OFF key to turn the
power ON.
All the display symbols will turn on.
After a few seconds, the display turns
off once.
automatically read the zero point
(power-on zero) and the display
shows zero.
2. Press the ON/OFF key again, and
the power will be switched OFF.
Auto-power off function
It is possible to have the power
automatically switched OFF, if zero is
displayed for approximately 5 minutes.
See "9-2. Functions" and set the F-
Function f-04-05 to "1" to enable the
function.
ZERO
The ZERO key will bring the weight display back to zero.
1. Remove everything from the weighing pan and press the ZERO key. Then the
weight display shows "-------" and waits for the weighing data to become stable.
2. The scale will zero and the ZERO indicator will
come ON to indicate that the scale is ready to start
weighing or counting.
There is an automatic re-zeroing function called
"Zero Tracking". The scale initially comes with this
function enabled to take care of normal drift from
zero caused by changes in temperature, humidity,
air pressure etc. (F-Function f-04-01).
3. BASIC OPERATIONS
Then, the scale
888. 8 . 8 . 8 . 8 . 8
TOTAL
will
M+
SAMPLE
TOO LIGHT
WEIGHT
888. 8 . 8 . 8 . 8
STABLE
TARE
ENTERED
ZERO
888. 8 . 8 . 8
TOTAL
M+
SAMPLE
TOO LIGHT
WEIGHT
8880. 0
STABLE
TARE
ENTERED
ZERO
STABLE
ENTERED
9
ON
OFF
COUNT
HI OK LO
UNIT WEIGHT
8 8. 8 . 8 . 8 . 8 . 8 .
8
ACAI
COUNT
80
HI OK LO
UNIT WEIGHT
008 0. 0 0000
8
ACAI
WEIGHT
8880. 0 00
TARE
ZERO