15. OP-08 EXTENSION CABLE
The display pod can be separated from the scale base by using the optional extension
cable. The cable between the display pod and the base is approximately 2m long.
1. Disconnect the AC adapter from the scale. If the battery is used, switch off the scale.
2. Remove 6 screws and the display support plate.
M6 screws
M4 screws
Display support plate
2. Remove the screw fixing the cable
clamp and carefully disconnect the
cable between the display pod and
the base.
3. Squeeze the bushing on the CAL switch
cover and pull the cable out.
4. Attach the optional cable to the CAL switch cover with the bushing.
Carefully connect the cable connectors to the scale as the original cable was.
5. Attach the display support plate as shown,
using 4 M6 screws removed at step 2.
Cable clamp
Display support plate
Change this cable with
the 2m extension cable.
Connectors
CAL switch cover
Bushing
M6 screws
Extension cable
54