Caring For The Label Maker; Cleaning The Label Maker; Cleaning The Print Head - Dymo XTL 500 User Manual

Caring for the Label Maker

Your label maker is designed to give you long and trouble-free service, while
requiring only occasional maintenance.
Clean your label maker from time to time to keep it
working properly.
A cleaning tool is located inside the label compartment
cover. The tool has two pads, a felt pad for cleaning the
print head and a sponge pad for cleaning the sensors.
See Figure 11.

Cleaning the Label Maker

 Clean the keypad, display, and outside of the label maker using a soft damp
cloth.
Do not put water or any other liquid directly on the display or keypad.
 Clean the inside of the label compartment using a small, soft brush or cotton
swab to wipe away stray particles.

Cleaning the Print Head

To keep printing clear and crisp labels, occasionally clean the print head. Use the
cleaning tool that came with your label maker.
The print head is very delicate, so use care when cleaning.
To clean the print head
Press the label compartment
1
release and lift the cover.
Remove the label cartridge.
2
Remove the cleaning tool from
3
inside the label compartment
cover. See Figure 11.
Gently wipe the felt side of the tool
4
across the print head. See
Figure 12.
Replace the cleaning tool, insert
5
the label cartridge, and close the
cover.
™
47 XTL 500
User Guide
Cleaning tool
Figure 11
Cleaning
tool
Print
head
Figure 12