How To Reset Pilot Setting - Furuno FAR-2107 Operator's Manual

Function
Off-centering
Target Trails Display, Time
Mode
Past Position Display
Vector mode
Vector time
AZ1
AZ2
TT acquisition mode
AIS Display
Association
Lost Target Alert
CPA/TCPA On/OFF
alarm
CPA
TCPA
*1: In the case of B, C and W types, the menu layout is [MENU] > 2 [MARK] > 2 [EBL1].
*2: In the case of B, C and W types, the menu layout is [MENU] > 2 [MARK] > 3 [EBL2].
*3: In the case of IMO type, this menu is not available. The setting is fixed to "true".
*4: Has the same effect as choosing True Motion mode.
1.56.1

How to reset PILOT SETTING

1. Right-click the USER SET box to open the [USER
SET] menu.
2. Select 1 [PILOT SETTING].
3. Select [YES] to reset PILOT SETTING.
Note 1: Items not shown in the table above (EG: Gain,
A/C SEA, A/C Rain, etc.) keep their previous settings
when PILOT SETTING is activated.
Note 2: TT tracking is continued after PILOT SETTING is
activated.
Note 3: The radar map displays the same map as before
PILOT SETTING activation.
Settings
On-centering *4
ON, 6 MIN
TRUE
OFF
REL
6 MIN
OFF
OFF
MAN100
DISP ALL
ON (TT > AIS)
OFF (Disable the alert)
ON
2 NM
12 MIN
1. RADAR OPERATION
Remarks
[OFF CENTER] key
TRAIL MODE Box
[TRAIL MENU] > 1 [TRAIL MODE]
PAST POSN Box
TT VECTOR Box
AZ1 Box
AZ2 Box
[TT TARGET MENU] > 1 [TT
SELECT]
AIS DISP Box
[MENU] > 4 [TT・AIS] > 0
[ASSOCIATION]
LOST TARGET Box
CPA LIMIT Box
CPA Box
TCPA Box
[USER SET MENU]
1 PILOT SETTING
NO/YES
2 USER 1 LOAD
NO/YES
3 USER 1 SAVE
NO/YES
4 USER 2 LOAD
NO/YES
5 USER 2 SAVE
NO/YES
1-111