How To Reset The User Settings; How To Store/Load User Settings - Furuno FAR-1513-BB Operator's Manual

1. OPERATIONAL OVERVIEW
Function
Vector mode
Vector time
AZ1
AZ2
TT acquisition mode
AIS display
Association
Lost Target Alert
CPA/ ON/OFF
TCPA
CPA
alarm
TCPA
1
* : This menu is not available for IMO type and the setting is fixed to [TRUE].
2
* : Has the same effect as selecting the True Motion presentation mode.
1.14.1

How to reset the user settings

1. Select the [USER SET] box, then press the right
button to display the [USER SET MENU].
2. Select [PILOT SETTING], then push the ADJUST
knob.
3. Select [YES], then push the ADJUST knob.
4. Close the menu.
Note 1: Items not shown in the above table keep their
previous settings when [PILOT SETTING] is activated.
Note 2: TT tracking is continued after [PILOT SETTING]
is activated.
Note 3: The radar map displays the same map as before [PILOT SETTING] is activat-
ed.
1.14.2

How to store/load user settings

1. Select the [USER SET] box, then press the right button to display the [USER
SET MENU].
2. Select [USER1(2) LOAD] or [USER1(2) SAVE] to recall or save user settings, re-
spectively, then push the ADJUST knob.
3. Select [YES], then push the ADJUST knob.
4. Close the menu.
When loading settings, the following points apply:
• If the newly loaded settings cannot be applied to items not listed in the table above,
then these items keep their previous settings.
• TT tracking is continued after the settings are loaded.
• The radar map displays the same map as before the settings were loaded.
1-16
Setting(s)
Continued from previous page
[REL] [VECTOR] box
[6 MIN]
[OFF] [AZ1] box
[OFF] [AZ2] box
[MAN50] [TT TARGET]
[DISP ALL] [AIS] box
[ON] (TT > AIS) [MAIN MENU]
[OFF] (Disabled) LOST TARGET ALERT box
[ON] [CPA LIMIT] box
[2 NM]
[12 MIN]
Menu/On-screen box
[TT SELECT]
[TT•AIS]
[ASSOCIATION TGT]
[USER SET MENU]
1 PILOT SETTING
NO / YES
2 USER1 LOAD
NO / YES
3 USER1 SAVE
NO / YES
4 USER2 LOAD
NO / YES
5 USER2 SAVE
NO / YES
[ASSOCIATION]