Erasing Waypoints - Furuno FAR-2107 Operator's Manual

5.10.3

Erasing waypoints

Waypoints may be erased individually or collectively. Note that a waypoint
cannot be erased if it is part of a nav line.
Erasing individual waypoints
1. With the cursor inside the effective display area, roll the scrollwheel to display
"MARK DELETE / EXIT" in the guidance box.
2. Use the trackball to put the cursor on the waypoint you wish to erase. A
flashing "+" appears on the mark when it is correctly selected.
3. Push the left button or the scrollwheel to erase the waypoint.
4. To erase another waypoint, repeat steps 2 and 3.
5. To finish, push the right button when the guidance reads "MARK DELETE /
EXIT".
Erasing all waypoints
1. Left-click the MENU box to open the menu.
2. Select 5 [PLOTTER] to open the PLOTTER menu.
3. Select 8 [DATA ERASE].
4. Select 5 WPT ALL ERASE.
5. Select YES to erase all waypoints.
6. Push the right button three times to close the menu.
[DATA ERASE]
1 BACK
2 OWN TRACK* 1
RED/GRN/BLU/YEL/
CYA/MAG/WHT/
30%/50%/80%/ALL
2
3 TARGET TRACK*
RED/GRN/BLU/YEL/
CYA/MAG/WHT/
30%/50%/80%/ALL
4 MARK ALL ERASE
NO/YES
5 WPT ALL ERASE
NO/YES
6 NAV LINE ALL ERASE
NO/YES
7 OWN TRACK DELETE*
2POINTS/AREA
8 TARGET TRACK DELETE*
2POINTS/AREA
DATA ERASE menu
5. VIDEO PLOTTER OPERATION
3
* 1 Colors not shown on IMO type
2
* Not available on IMO type
3
3
* Not available on IMO or A type
5-21