WARNING
Observe the following instructions for lifting the vehicle.
If the wheel has to be changed on a slope, first of all block the opposite
■
wheel with a stone or similar object to prevent the vehicle from unexpectedly
rolling away.
Secure the base plate of the lifting jack with suitable means to prevent pos-
■
sible moving. A soft and slippery ground under the base plate may move the
lifting jack, causing the vehicle to fall down. It is therefore always necessary to
place the lifting jack on a solid surface or use a wide and stable base. Use a
non-slip base (e.g. a rubber foot mat) if the surface is smooth, such as cobbled
stones, tiled floor, etc.
Only attach the lifting jack to the attachment points provided for this pur-
■
pose.
Always raise the vehicle with the doors closed.
■
Never position any body parts, such as arms or legs under the vehicle, while
■
the vehicle is raised with a lifting jack.
Never start the engine when the vehicle is raised – risk of injury.
■
CAUTION
The tightening torque specified for the wheel bolts for steel and light alloy
■
wheels is 120 Nm.
The anti-theft wheel bolt or the adapter can be damaged if the wheel bolts are
■
tightened too much.
Note
The anti-theft wheel bolt set and adapter can be purchased from a ŠKODA Part-
■
ner.
The national legal requirements must be observed when changing a wheel.
■
Preliminary work
First read and observe the introductory information and safety warn-
ings
on page 180.
Always change a wheel on a level surface as far as possible.
The following steps must be carried out before actually changing the wheel:
›
Have all the occupants get out. The passengers should not stand on the road
(instead they should remain behind a crash barrier, for instance) while the
wheel is being changed.
›
Switch off the engine.
›
Move the gearshift lever into Neutral or move the selector lever for the auto-
matic gearbox into position P.
›
Apply the handbrake firmly.
›
Uncouple a trailer.
›
Remove the vehicle tool kit
wheel from the boot.
Changing a wheel
First read and observe the introductory information and safety warn-
ings
on page 180.
›
Remove the full wheel trim
» page 177
›
In the case of light alloy wheel rims remove the wheel trim cap
›
First of all slacken the anti-theft wheel bolt and then the other wheel
bolts
» page
182.
›
Jack up the vehicle until the wheel that needs changing is clear of the
ground
» page
183.
›
Unscrew the wheel bolts and place them on a clean surface (cloth, paper, etc.).
›
Remove the wheel carefully.
›
Attach the spare wheel and slightly screw on the wheel bolts.
›
Lower the vehicle.
›
Tighten the opposite wheel bolts alternately (cross-wise) with the wheel
wrench. Tighten the anti-theft wheel bolt last
›
Reinstall the wheel trim/wheel trim cap or the caps.
Note
All bolts must be clean and must turn easily.
■
Under no circumstances grease or oil the wheel bolts!
■
When fitting unidirectional tyres, ensure that the direction of rotation is cor-
■
rect
» page
172.
» page 180
and the spare wheel
» page
or caps
» page
177.
» page
182.
Emergency equipment and self-help
176, Spare
» page
177.
181