Skoda Roomster Owner's Manual page 117

Storing a speed

First read and observe the introductory information and safety warn-
ings on page 113.
Storing a speed
›
Press switch » Fig. 101 to the ON position.
A
›
After the desired speed has been reached, press the rocker button
SET position.
After you have released the rocker button
you have just stored is maintained at a constant speed without having to depress
the accelerator.
Changing a stored speed

First read and observe the introductory information and safety warn-
ings on page 113.
Increasing the speed with the accelerator
›
Depress the accelerator to increase the speed.
›
Release the accelerator to reduce the speed back down to the preset speed.
However, if the saved speed is exceeded by more than 10 km/h for a period of
more than 5 minutes by depressing the accelerator, the stored speed is deleted
from the memory. The speed must then be saved again.
Increasing the speed with the rocker button
›
Press rocker button » Fig. 101
B
›
The speed will increase continuously, if the rocker button is pressed and held in
the RES position. Release the rocker button once the desired speed is reached.
The set speed is then stored in the memory.
114
Driving
Fig. 101
Operating lever: Operating the
cruise control system
out of the position SET, the speed
B
B
on page 114 to the RES position.
Decreasing the speed
›
The stored speed can be reduced by pressing rocker button
page 114 to the SET position.
›
The speed will decrease continuously, if the rocker button is pressed and held in
the SET position. Release the rocker button once the desired speed is reached.
The set speed is then stored in the memory.
›
If the rocker button is released at a speed below around 25 km/h, the speed is
not stored and the memory is erased. The speed must then be stored again by
pressing rocker button
vehicle to more than around 25 km/h.
The speed can also be reduced by depressing the brake pedal, which temporarily
deactivates the system.
Switching off temporarily

First read and observe the introductory information and safety warn-
ings on page 113.
into the
B
The cruise control system can be temporarily switched off by pushing switch
» Fig. 101 on page 114 to the spring-loaded CANCEL position or by depressing
A
the brake or clutch pedal.
The set speed remains stored in the memory.

Briefly push rocker button
the clutch or brake pedal is released.
Switching off completely

First read and observe the introductory information and safety warn-
ings on page 113.
›
Press switch
A
to the SET position after increasing the speed of the
B
to the RES position to resume the set speed after
B
» Fig. 101 on page 114 to the right to the OFF position.
» Fig. 101 on
B


