Fig. 31 - Skoda Roomster Owner's Manual

Hide thumbs Also See for Roomster:
Table of Contents

Advertisement

WARNING
Properly maintained windscreen wiper blades are essential for clear visibility
and safe driving
» page
50.
Do not use the windscreen washer system at low temperatures, without
heating the windscreen beforehand. Otherwise the window cleaner could
freeze on the windscreen and restrict the view to the front.
Replace the windscreen wiper blades once or twice a year for safety rea-
sons. These can be purchased from a ŠKODA Partner.
CAUTION
In cold temperatures and during the winter, check before the journey or before
switching on the ignition that the wiper blades are not frozen to the windscreen.
If the windscreen wipers are switched on when the blades are frozen to the
windscreen, this may damage both the blades and windscreen wiper motor!
If the ignition is switched off while the windscreen wipers are switched on, the
windscreen wipers will continue wiping in the same mode after the ignition is
turned back on. The windscreen wipers could freeze up in cold temperatures be-
tween the time the ignition was turned off and when it was turned back on again.
Carefully detach frozen wiper blades from the front or rear window.
Remove snow and ice from the windscreen wipers before driving.
If the windscreen wipers are handled carelessly, there is a risk of damage to the
windscreen.
Note
The windscreen washer nozzles for the windscreen are heated when the en-
gine is running and the outside temperature is less than approx. +10 °C.
The content of the windscreen washer fluid reservoir is 3.5 litres. On vehicles
fitted with the headlight cleaning system, the volume is around 5.4 litres.
The wiper blades should be cleaned on a regular basis with a windscreen clean-
er to avoid any smears. The wiper blades should be cleaned with a sponge or
cloth if they are heavily soiled by insect residues, for example.
Windscreen wiper and washer
First read and observe the introductory information and safety warn-
ings
on page 48.
Control stalk positions
» Fig.
31.
Wipers off
0
Interval windscreen wiping
1
Slow windscreen wiping
2
Rapid windscreen wiping
3
Single windscreen wipe (spring-loaded position)
4
Automatic wipe/wash for windscreen (spring-loaded position)
5
Wiping the rear window (the windscreen wiper wipes at regular intervals af-
6
ter a few seconds)
Automatic wipe/wash for the rear window (spring-loaded position)
7
Switch for setting the desired interval between the individual windscreen
A
wipes (
Interval windscreen wiping)
1
Automatic wipe/wash for windscreen
The wash system operates immediately, the windscreen wipers wipe somewhat
later.
Releasing the lever will stop the windscreen washer while the wipers continue
for another 1 to 3 wiper strokes (depending on the period the windscreen has
been sprayed).
Automatic wipe/wash for the rear window
The wash system operates immediately, the wiper wipes somewhat later.
Releasing the lever will stop the washer while the wipers continue for another 1
to 3 wiper strokes (depending on the period the window has been sprayed). The
lever will stay in position after releasing it

Fig. 31

Operating lever: Windscreen
wipers and washer settings
.
6
49
Lights and visibility

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents