Skoda Roomster Owner's Manual page 42

Note
After switching the ignition off, it is still possible to open or close the windows
■
for approx. 10 minutes. The electrical power windows are only switched off com-
pletely once the driver's door or front passenger door are opened.
When driving always use the existing heating, air conditioning and ventilation
■
system for ventilating the interior of the vehicle. If the windows are opened, dust
as well as other dirt can get into the vehicle and in addition the wind noise is
more at certain speeds.
Opening/closing the windows
Fig. 20 Buttons on the driver's door/in the rear doors

First read and observe the introductory information and safety warn-
ings on page 38.
Power window buttons » Fig. 20.
Button for electrical power window of the driver's door
A
Button for electrical power window of the front passenger door
B
C Button for electrical power window of the rear right door
Button for electrical power window of the rear left door
D
Safety pushbutton
S
The electrical power windows can only be operated when the ignition is switched
on.
Opening
›
The window is opened by pressing lightly on the corresponding button. The
opening process stops when one releases the button.
The window will also open fully automatically if you briefly press the button as far
as the stop. Renewed pressing of the button causes the window to stop immedi-
ately.
Closing
›
The window is closed by pulling lightly on the corresponding upper edge of the
button. The closing process stops when one releases the button.
The window will also close fully automatically if you briefly pull the button as far
as the stop. Renewed pulling of the button causes the window to stop immedi-

ately.
Safety pushbutton
The buttons for power windows in the rear doors can be deactivated by pressing
the safety switch » Fig. 20. The buttons for the electrical power windows in
S
rear doors are activated again by pressing the safety pushbutton
If the buttons for the rear doors are deactivated, the warning light  in the safe-
ty switch lights up.
S
Note
The window lift mechanism is equipped with protection against overheating. Re-
peated opening and closing of the window can cause this mechanism to over-
heat. If this happens, it will not be possible to operate the window for a short
time. You will be able to operate the window again as soon as the overheating
protection has cooled down.
Power window force limiter

First read and observe the introductory information and safety warn-
ings on page 38.
The electrical power windows are fitted with a force limiter. It reduces the risk of
bruises or injuries when closing the windows.
If there is an obstacle, the closing process is stopped and the window goes down
by several centimetres.
If the obstacle prevents the window from being closed during the next 10 sec-
onds, the closing process is interrupted once again and the window goes down by
several centimetres.
again.
S


39
Unlocking and locking