Information Messages; Manually Activating/Deactivating The System - Skoda Roomster Owner's Manual

›
The engine has not yet reached the minimum temperature for the START STOP
mode.
›
The temperature inside the vehicle has not reached the desired temperature
set in the air-conditioning system/heating.
›
The external temperature is very low/high.
›
Intensive windscreen deicing (Climatronic) or windscreen deicing/ventilation is
switched on at the maximum air temperature setting (manual air conditioning
system).
›
The parking aid is activated.
›
The charge state of the vehicle battery is too low.
›
The stationary vehicle is on a steep hill or a steep slope.
›
The idling speed is too high.
›
The steering angle is too great (manoeuvring).
The  warning symbol is being shown in the instrument cluster display.
The automatic start procedure runs again
During the STOP phase, the engine fires up without any active driver intervention,
e.g. in the following situations.
›
The vehicle has begun to roll, e.g. on a slope.
›
The difference between the temperature setting of the air-conditioning sys-
tem/heating and the temperature of the interior is too great.
›
Intensive windscreen deicing (Climatronic) or windscreen deicing/ventilation is
switched on at the maximum air temperature setting (manual air conditioning
system).
›
The brake pedal was pressed several times (the pressure in the braking system
is too low).
›
The charge state of the vehicle battery is too low.
›
The current consumption is too high.

Manually activating/deactivating the system

116
Driving
Fig. 102
Button for the START-STOP sys-
tem

First read and observe the introductory information and safety warn-
ings on page 115.
Activation/deactivation
›
Press the  button » Fig. 102.
When start-stop mode is deactivated, the warning light in the button lights up.
Note
If the system is deactivated during the STOP phase, the automatic start proce-
dure runs.

Information messages


First read and observe the introductory information and safety warn-
ings on page 115.
The messages and information are indicated in the instrument cluster display.
Start the engine manually.

START MANUALLY

The driver sees this message when the conditions for the automatic start proce-
dure are not met during the STOP phase. The engine must be started manually.
Fault: start-stop system

ERROR START-STOP

Fault in the START-STOP system. Seek help from a specialist garage.


