Remove Effect Wheel Module; Install Effect Wheel Module; Replace Effect Wheel Motor; E F F E C T W H E E L - Martin MAC 2000 Performance Service Manual

MAC 2000 Performance Service Manual

E F F E C T W H E E L

R E M O V E E F F E C T W H E E L M O D U L E
1 Remove the framing module (p. 4).
2 Remove one of the effects from the
effect wheel.
3 Using a short screwdriver
equivalent, remove the 4 screws that
fasten the effect wheel module to the
zoom / focus module.
4 Unplug the effect wheel motor as you
remove the module.
I N S T A L L E F F E C T W H E E L M O D U L E
1 Plug in the effect wheel motor. Turn the
motor so that the socket points down
and insert the motor through the rear
plate of the zoom / focus module. The
triangular corner of the module plate
points towards the junction print.
2 Align the screw holes and fasten with
P/N 08070801, "M4x8 screw, Torx, cs,
black", instead of the original taptites.
3 Install the effect in the effect wheel.
4 Install the framing module.
R E P L A C E E F F E C T W H E E L M O T O R
1 Remove the effect wheel module.
2 Loosen the set screws and pull the
effect wheel off of the motor shaft.
3 Unscrew the old motor from the plate.
Install a new motor with the plug facing
away from the triangular corner.
4 Place the effect wheel on the motor
shaft. Do not tighten the set screws.
5 Reinstall the module and adjust. (p. 33)
Effect wheel
or
31