Gobo Animation Wheel; Replace Position Belt; G O B O A N I M A T I O N W H E E L - Martin MAC 2000 Performance Service Manual

1. rotation belt
2. rotation belt tensioner

3. gobo animation wheel

4. sliding assembly
5. guide rail retaining bracket
6. inside guide rail
7. position belt tensioner
8. position motor
9. rotation motor
10. outside guide rail
11. position belt
MAC 2000 Performance Service Manual

G O B O A N I M A T I O N W H E E L

1
2
3
4
5
6
7
8
R E P L A C E P O S I T I O N B E L T
1 Remove the gobo animation wheel.
2 Release belt tension and work the position
belt off the end pulley closest to the motor.
Remove the 2 guide rail retaining brackets.
Snap the guide rails out of the plastic clips.
3 Work the belts off the pulleys.
4 Remove the sliding assembly from the
guide rails and loosen the belt clamp.
Remove the old belt and install the new one
with the teeth facing the clamp. Tighten the
clamp.
5 Put the sliding assembly in its approximate
location to remove twist. Lead the belt
down through the motor hole and up over
the gear.
6 Snap the inside guide rail into the clip, then
work the belt over the tensioner and end
pulleys.
Gobo animation wheel
9
10
11
13