Replace Gobo Wheel Motor - Martin MAC 2000 Performance Service Manual

MAC 2000 Performance Service Manual
7 Arrange the motor spacer as shown.
8 Place the motor as shown and fasten.
9 Place the belt over the motor and then
press the gobo wheel onto the bearing.
Replace the snap ring. Work the belt over
the wheel rotation motor.
10 To make it easier to adjust later, align the
magnet on the gobo wheel with the sensor
and, while holding the gobo wheel, turn the
motor adaptor so the set screw points
outward. Pull back on the motor to tighten
the belt and then tighten the motor screws.
11 Replace the gobo holder.
12 Replace the silicone gobo rotation gear
with three new M3 x 4 mm countersunk
screws.
13 Reassemble and install the module.
R E P L A C E G O B O W H E E L
M O T O R
1 Separate the gobo
framing/iris module.
2 Remove the 3 screws and remove the gobo
wheel motor.
Gobo wheel
module from the
17