M O D U L E D I S A S S E M B L Y
1. cable guard
2. framing rotation stop
3. framing wheel and iris
4. framing wheel rack
5. guide-wheel levers
6. framing plate
7. gobo module
S E P A R A T E T H E F R A M I N G / I R I S M O D U L E
1
2
3
4
5
MAC 2000 Performance Service Manual
To avoid damaging the iris belt when removing
and replacing, remove the iris motor gear from
the motor shaft.
Remove the cable guard.
Align the framing rotation stop with the access
hole in the framing plate.
Pull the springed guide wheel levers back to
release the module, you can remove springs to
make this easier, and lift out the rotating assembly.
Installation is the reverse. Important note: Avoid twisting the cable bundle when
replacing the rotating assembly .
Module disassembly
5
6
5
1
2
3
4
5