Connecting The Probe Cable; Figure 2.3-1 Connecting The Probe Cable - Fujitsu MB2145-507 Hardware Manual

2.3

Connecting the Probe Cable

Connect the probe cable to the probe cable connector on the top of the emulation pod
as shown in Figure 2.3-1.
Connecting the Probe Cable
CAUTION
Prohibition Before connecting or disconnecting a cable, turn off the power.
Failure to do so may cause an electric shock.
When disconnecting a cable, hold the cable by the connector case.
Do not pull on the cable.
Doing so may break a wire in the cable.

Figure 2.3-1 Connecting the Probe Cable

2.3 Connecting the Probe Cable
19