Inserting/Ejecting The Data Cartridge - Fujitsu PRIMERGY LTO2 User Manual

- When the tape operating time exceeds 100 hours
Once CLEAN LED turns on, it does not turn off until cleaning is performed correctly. (The
LED does not turn off even when the power is turned off.) When CLEAN LED turns on,
perform cleaning using the cleaning cartridge.
When READY LED is blinking rapidly, do not insert a data cartridge. Doing so may
destroy data. Wait for 15 seconds, and perform operations after the rapid blinking has
stopped.
2.2

Inserting/Ejecting the Data Cartridge

Handle the data cartridge properly referring to "3 About the Data Cartridge" ( pg.59).
How to insert
Insert the data cartridge slowly into the product, with the arrow mark facing up and the label panel
facing you. When the cartridge is fully inserted, it starts loading automatically.
To avoid damaging the product and the cartridge, note the following points.
• Do not use too much force.
• Insert the cartridge straight at the correct position in correct direction.
If you want to perform backup or restore operations immediately after inserting the data
cartridge, wait until the data cartridge is completely loaded (until the READY LED turns on).
Arrow mark (insert direction)
Label area
2 Componet Names and Functions
E
57