MENU OPERATIONS
CLOCK SETTING
To perform the CLOCK setting in power or standby mode, in power mode, press the clock but-
ton the display will show the current time.(F1)
A: 1. Press and hold the CLOCK button on the remote, until the hour digits flash in the display.
2. Press SKIP/TUNING (DOWN or UP) button to set to the correct hour and press
the CLOCK button on the remote again the minute digits will flash .press the SKIP/
TUNING (DOWN or UP) to set to the correct minute. Then press the clock button again to
confirm.
B: 1. Press the MENU button on the unit (or remote) the display will show "CLOCK".
2. Press the PLAY/PAUSE button the hour digits flash in the display, press the SKIP/
TUNING (DOWN or UP) button to set to the correct hour and press the PLAY/PAUSE
button again the minute digits will flash, press the SKIP/TUNING (DOWN or UP) to set to
the correct minute.
Then press the PLAY/PAUSE button again to confirm.(F2)(F3)(F4)
3. Press the STOP/BAND button to perform the clock setting .
NOTE: Each enable state as shown above will be cleared, if the button is not. press in 10
seconds.
ENG - 74