WMF WMF1000 User Manual page 51

Flow fault
(water tank is full)
EEPROM Error
Motor driver error
Grinder blocked
Temperature sensor
steam
Temperature sensor
water
Timeout level
WMF 1000 user manual
Air in the system, possibly associated with loud pump
noise:
Check whether the water tank is pushed in completely
Bleed machine: Dispense hot water until a constant
stream of water comes out
No hot water dispensing:
Remove tank filter/dirt trap from tank, try again
Brewing unit stopped up:
Remove brewing unit, clean manually, insert and carry
out cleaning program
Clean brewing unit, see Chapter 6 Customer Care > Brewing unit
If the error occurs sporadically:
Set grinding degree coarser
Switch off pre-brew
Switch machine on/off
If the error repeats, the fault must be eliminated by the
WMF 1000 Service-Center.
See chapter WMF 1000 Service-Center
Switch machine on/off
If the error repeats, the fault must be eliminated by the
WMF 1000 Service-Center.
The grinders are blocked by foreign bodies:
To eliminate, see section "Manual cleaning"
Clean bean hopper; switch off machine, turn grinders
clockwise with the multitool in order to be able to
remove foreign bodies
See Chapter 5 Other Settings
Grinding degree too fine:
Set grinding degree coarser
Switch off coffee machine, allow to cool and switch on
again
If the error repeats, the fault must be eliminated by the
WMF 1000 Service-Center.
Air in the system, possibly associated with loud pump
noise:
Check whether the water tank is pushed in completely
Take milk hose out of the milk container and press the
milk foam button
If hot water comes out instead of steam:
Carry out descaling
If steam comes out:
Please call the hotline
Messages and tips
51